Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Access privillage to Username


Can any one guide me setting up the privillages for the username in router and switches

in router we created the username and given the privillage to 15 which was fine having full access to config

but we need one more username to see only the running config and not to modify the configuration on the router

i tried by giving the access privilage level starting from 1 to 15 like the below but nothing made different except 1 and 15

username admin privillage 15 password cisco

username admin1 privillage 7 password cisco1

can i know what are feature for level 0 15 so that i will use accordingly

thnaks in advance


Re: Access privillage to Username


You set the privileges that you want your users to have.

15 is ALL privileges, and 1 is nothing (pretty much).

You can set your privilege levels in global config:

privilege exec level 3 show running-config

username test privilege 3 pass test

The problem with this is when you do a show run under this user account, it will be blank. You'll have to give your levels appropriate access to everything you want them to see.

privilege configure level 3 access-list

The above will allow the level 3 user to see an access-list in the running config. As you can see, it can get very monotonous to configure. You may want to look into views which is much easier to configure, and much more consistent.



HTH, John *** Please rate all useful posts ***
New Member

Re: Access privillage to Username

Thanks for your reply

for viewing the access-list alone we need to configre privillage configure level 3 acccess-list

if we need to show all the config except the username and password then LINE as to be mentioned

CreatePlease login to create content