If a router is running as a DHCP Server for the Private LAN, than how is it possible to automatically given the dhcp-clients the address of Proxy Server which is residing on the public WAN.
The local network is on 10 network and Public network is on 188.8.131.52/29 network. The Proxy Server IP is 184.108.40.206. I want the DHCP-Server of the router to advertise this address as well to the clients.
The HTTP proxy settings of a client are attributes of the Web Browser application. It is not therefore possible to configure the proxy server configuration of a client from the DHCP server. It might be possible to use destination NAT to force all port 80 traffic to go to the Proxy server but such a config would not be advisable or supported since the client/proxy server would not be interacting correctly.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...