Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

ACE cards problem in 6500 with VSS

Hello,

I have 2 6500-E configured in VSS and I have on each 6500 one ACE card and one FWSM card. My problem is that I have only one ACE card OK and the other in PwrDown or Other status at the same time. There are never the two card in OK Status at the same time. The ACE card is OK only in the 6500 which is Active VSS, never in the 6500 VSS standby.

Have I forgot something to do ?

Best regards.

3 REPLIES

Re: ACE cards problem in 6500 with VSS

Hi Mauricio,

Can you post the "show version" and "show module switch all" of the VSS.

Regards

Tomoyuki

Silver

Re: ACE cards problem in 6500 with VSS

Hi,

you need at least version 12.2(33)SXI for this.

Take a look at following document:

http://www.cisco.com/en/US/products/ps9336/products_tech_note09186a0080a7c72b.shtml

HTH,

Dario

New Member

Re: ACE cards problem in 6500 with VSS

Hi Mauricio,

You need to run minimum version A2(1.3) on your ACE module and 12.2(33)SXI on your 6500 chassis.

If you run a version before A2(1.3) your ACE module status will be:

. OK on the Actice VSS

. PwrDown on the Standby VSS

You need to move you ACE module to the Active switch of your VSS set and upgrade to A2(1.3).

Regards,

Christophe

350
Views
0
Helpful
3
Replies
CreatePlease to create content