Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

fly
New Member

acl for traffic!

r1----(G1)6509(VLAN10)------computer

i config acl (deny any any)apply to interface vlan10 on 6509, whatever in or out, I found i can ping vlan 10 interface ip address from R1.

But i can't ping vlan 10 interface ip address in 6509.

how can i config acl to block traffic from r1 to reach interface vlan 10 on 6509.

I don't like place acl in G1 interface.

how can I block traffic originated with 6509 to reach interface vlan 10 interface ip address or computer below it!

thank you!

3 REPLIES
Cisco Employee

Re: acl for traffic!

Do you want to block the traffic with in the Vlan 10. Please explain it again.

-amit singh

New Member

Re: acl for traffic!

and paste ur config pls...

ciao flash

fly
New Member

Re: acl for traffic!

r1----(g1)6509(vlan10)-----computer

i want block traffic from r1 to computer in vlan 10.

I know i can config acl on interface g1. But customer don't agree.

i config one acl ,and apply to interface vlan 10 on 6509. both in and out

acl is simple deny ip any any.

I found i can ping vlan 10 interface ip address from r1.

but i can't ping vlan 10 interface ip address in 6509 .

customer want block traffic from r1 to vlan 10 and also not reach vlan 10 interface ip address.

how can i do this, if i can't apply acl on interface G1.

thank you!

104
Views
0
Helpful
3
Replies