Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ACL help

I have an extended ACL configured on a router denying traffic from a host through port 80. The problem is it is not being applied to the interface. How can I bound this ACL to an interface? Is there any documentation out there that goes over these steps?

thanks

3 REPLIES
Hall of Fame Super Blue

Re: ACL help

Hi

You apply an acl to an interface with the following

int fa0/1

ip access-group "acl_name" in|out

HTH

Jon

New Member

Re: ACL help

Ok, thanks for the help. Is there a way to verify that it is attached to the interface?

Hall of Fame Super Silver

Re: ACL help

Sean

If you have configured the access list then the way that you apply it (or bind it) to the interface is with the command ip access-group in|out

If you are looking for documentation you could start with this link:

http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a0080430e5b.html#wp1066643

[edit] seeing your response - if you want to check that the ACL is bound to the interface I would suggest doing show ip interface . This output shows any inbound or outbound access lists that have been configured.

HTH

Rick

108
Views
10
Helpful
3
Replies