10-17-2006 07:14 AM - edited 03-05-2019 12:17 PM
Hi, I work with Catalyst 4006 + RSM. My interfaces are configured as trunks, and subinterfaces for each vlan: gigabit 3.1, 3.2, 4.1, 4.2, etc. I have an ACL applied on the inbound line vty and it is work ok. But for a subinterface don't work.
Cisco Internetwork Operating System Software
IOS (tm) L3 Switch/Router Software (CAT4232-IN-M), Version 12.0(10)W5(18f)
ROM: System Bootstrap, Version 12.0(7)W5(15b) RELEASE SOFTWARE
ROM: L3 Switch/Router Software (CAT4232-IN-M), Version 12.0(25)W5(27) RELEASE SOFTWARE
Router uptime is 19 weeks, 1 day, 19 hours, 31 minutes
System restarted by power-on at 17:00:07 edt3 Sun Jun 4 2006
Running default software
cisco Cat4232L3 (R5000) processor with 57344K/8192K bytes of memory.
R5000 processor, Implementation 35, Revision 2.1
Last reset from power-on
1 FastEthernet/IEEE 802.3 interface(s)
4 Gigabit Ethernet/IEEE 802.3z interface(s)
123K bytes of non-volatile configuration memory.
16384K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2
Anybody can help me?
Thks,
Paulo
10-20-2006 01:50 PM
I think the ACL type is mismatching in the subinterface
10-20-2006 07:37 PM
Can you share your configurations
Narayan
10-23-2006 04:54 AM
Hi Narayan,
I configured VLAN trunking on the two internal Gigabit Ethernet interfaces, from the supervisor engine as well as from the layer 3 Services module.
interface GigabitEthernet3.102
description Vlan Acesso Rede Adm SUN
encapsulation dot1Q 102
ip access-group 101 in
ip address 10.0.30.1 255.255.255.0
no ip redirects
no ip directed-broadcast
no cdp enable
access-list 101 permit ip 10.0.75.0 0.0.0.255 any log
access-list 101 permit ip host 10.0.65.16 any log
access-list 101 deny ip any any log
Thks,
Paulo Maur?cio
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: