I have a L3 switch (4506) in which i have created a vlan interface(VLAN-110) with below ip detail. L3 switch connected to L2 switch which has ports on vlan 100 to which machines are connected.
int vlan 110
ip address 10.110.160.0 255.255.255.0 secondary
ip address 10.110.170.0 255.255.255.0
I have two machines, machine-A has ip adress 10.110.170.50 and machine-B has ip 10.110.160.55. Now i want machine-A should not have connectivity to machine-B. So should applying ACL and calling this ACL over vlan110 interface would block communication. Is this best practice to do. Or we can do this in another recommended way. Pls help.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...