Vlan2 has Cisco 1130AG AP running on it, sending through to 192.168.3.0 for the DHCP (2 pools setup, one for each Vlan)
Trying to create ACL to permit data flow between Vlan1 and Vlan2, but to preserve flow of traffic outbound to the next hop (WAN) for each Vlan (which currently works).
For some reason, my ACL I think is stopping the DHCP pool for Vlan2 (where the 1130 AP is located) from releasing leases to these clients, as if I completely disassociate the ACL with the interfaces, everything works fine ? I might have a directional problem with the ACL, but I am SURE this is easy problem for someone to suggest a fix.. look forward to a response.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...