I'm taking a CCNA class and a classmate asked me why we have to begin the statements with the same command for the same access list? Would not be better to have a configuration mode for the access list you just created? For instance, when you want to configure F0/0, you type #conf t, and then (config)# int f0/0 and every command you enter next it will go under that interface. What he is saying is to type, for example, # conf t, (config)# access list 100, (config-acc)# and from there, permit or deny.....and everything falls under access list 100. If you want to switch to other access list, just type # access list and the number. My answer was, they must have a special reason rather than just letting you specify what statement goes for what access list, but that doesn't quite satisfies what now we want to know. Could anybody give us a good explanation or better answer? Thank you for you time!
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.