Can you please help with the following I have the following configured on my Nexus switches and works with success.
The problem I have is
Once I switch of the ACS server I can log on to the Nexus as I have a admin user configured locally on the Nexus and the ACS server unfortunately can not run commands as it tries to point to the ACS server for auhtorization and the ACS server is turned off is it possible for the Nexus to ignore the authorization command if it can not see the ACS server ?
ip tacacs source-interface vlan 705
tacacs-server host x.x.x.x key 7 "xxxxxx"
aaa group server tacacs+ Test-switch (Test-switch is a group configured on ACS 5.2)
aaa group server tacacs+ Test-switch
aaa authentication login default group Test-switch
aaa authorization config-commands default group Test-switch
aaa authorization commands default group Test-switch
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...