I am installing a NEW ACS Applinace Cisco ACS1113. I connected the console port of the ACS to the PC on serial port and trying to accesss the box through Hyper terminal. Hyperterminal baud rate is correct 115200 8 N 1 N. I can see the device is booting and giving the inofrmation that the appliance is working normal, acs is not configure to configure login as "Administrator" and type setup.
as per the installation guide it should prompt for a login : but i can not see any login prompt. i type Administratorand Enter but no response i can see on the hyper terminal.
what could be the problem???Is there any hardware failure ( no indication) or am i missing somne thing... ??? do i need to provide Software cd at this point???
change the baud rate back to 9600. Even when I did this when a new line would scroll it would erase what was on the screen so it was a little bit annoying. Once you get an IP address, and passwords then web into the box and you will most likely never use the console port again.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...