Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

add ports from EHWIC

Hi,

 

I have a 2921 router for BGP. Gi0/0 ans Gi0/1 are from ISPs. Gi0/2 is my local network.

I also have two EHWIC-D-8ESG ( Gi0/1/0-7 and Gi0/3/0-7).

How can I use those 16 ports in addition to Gi0/2 for my local network?

 

Thanks a lot!

3 REPLIES
Silver

Those ports are your

Those ports are your switchports on your router chassis - so understand them as "switch inside your router". Principles from switches work here also - you can configure only L3 SVI ports on them and then have some kind of similar behavior as your Gi0/2 routed port.

So make difference between these L2 switchports and your Gi0/2 routed port and that would be enough for you to know what setup you can accomplish.

HTH,

Dragan

HTH, Dragan
New Member

I'm far away..... :)So is it

I'm far away..... :)

So is it possible somehow to configure them for LAN instead of Gi0/2?

 

Thanks

Silver

Offcourse Adrian - configure

Offcourse Adrian - configure vlans on it and put your ports in appropriate vlan and you're ready to go...more on:

http://www.cisco.com/c/en/us/td/docs/routers/access/interfaces/software/feature/guide/geshwic_cfg.pdf

HTH,

Dragan

HTH, Dragan
46
Views
0
Helpful
3
Replies
CreatePlease to create content