You don't need to consider VTP settings anymore when adding switch into a stack or creating a stack. Just be sure that the switch that you are going to add to the stack has a lower priority than the master. The configuration of the master will always prevail. VTP and VLAN configurations. Because if you are going to add a new switch into a stack and that switch has a higher switch priority number, the existing switch might reboot and adopt the settings and VLAN and VTP configuration of the added switch.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...