Adding a Secondary IP Address on a Cisco ASA Ethernet Interface ??
I was just wondering if this is possible on a 5505. Please Advise. I need the interface to have traffic to 22.214.171.124 and 172.16.58.0. The interface is set up for 51.0 and I have created access rules for 58.0 but I can only get one way traffic. I was able to work around this on the SA500 and get this working. But the ASA 5505 does not allow for this????
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...