i have 2 2948g-l3 connected together using the gigaports with HSRP enabled. Port 1 of switch A is connected on port 2 of the router (1800 series) and port 1 of switch B is connected on port 3 of the router. All remaining ports are used.
The L3 switches handle all inter-vlan information.
My question is based on adding a third 2948g-l3. I added the third switch by connecting port 1 of switch C to port 48 of switch A and port 48 of switch C to port 48 of switch B . I never added switches before. I just want to make sure that i'm not missing anything.
I assumed that the switch A & B are responsible for the intervlan routing. Switch C vlans are going to the switch A or B for intervlan routing, but I didn't seen any trunk configuration on the switch C ports connected to the Switch A & B on ports 48.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...