cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
298
Views
0
Helpful
3
Replies

Adding new segment.

examples20001
Level 1
Level 1

Hi All,

I have to add new segment in my network and also change the subnet mask from /26 to/25.

What procedure can I follow to do this setup?

I have attached my network upgrade plan.

What all config need to be done in my L3 switch and L2 switch?

Can somebody suggest how to go for it?

3 Replies 3

kerek
Level 4
Level 4

HI,

If you don't want renumbering on the VLANs you can either use secondary subnets (undoubtly it also has some drawbacks) or create more VLAN's and route between them.

Hope it helps,

Krisztian

Attached file is the L3 switch config.

In show vlan, it is not showing the vlan20 and vlan21.

Hi,

Is the vlan20 created at all? I just see interface vlan20 but there is no any port assigned to vlan20. If you have created vlan20 on other switch (in vtp server mode) then vtp should advertise it through the rest (excluding vtp tranparent mode).

Hope it helps,

Krisztian

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco