I've read in multiple places that you can increase the number of virtual terminal lines by typing "line vty [some high number]". When I try on a 2511 with IOS 12.2 installed, it responds with an error: "Invalid input detected". When I try "line vty ?", it responds with "<0-4> First Line number". When I try "line vty 0 ?", it responds with "<1-4> Last Line number". How can I get more than 5 virtual terminal lines? Do I have to enable protocol translation or something? If so, how do I do that?
I figured out the solution to my wose. The version of IOS I was using did not support protocol translation and virtual asynchronous interfaces. By changing to the Remote Access Server feature set, I'm now able to have 182 vty lines.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...