"Could I adjust the queueing to make this more efficient?"
Perhaps. Much depends on whether there's insufficient bandwidth, where drops are going to happen, or whether there's insufficient device allocation. For instance, for the latter, increasing the buffer allocation for this traffic might decrease the drops.
Also you need to consider whether the drop rate % is high enough to be an issue (not the absolute number). Assuming your counters haven't wrapped, your drop percentage is only .006%, which often shouldn't be an issue.
Your issue may not be queue size related. It may be Flow control related. I see that you have Input flow control off. I would set flow control to on for both send and receive for your port. To verify if the port is being over run, use the show interface gig xx/yy flowcontrol command. If you have issues you will see them there. Enable the flowcontrol on both the switch and server or NAS or storage side on the NIC cards. Good Luck...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.