I'm suffering on the problem to adopt existing QoS configuration from our C3750 switches to the new C4900M switch series. I'm missing the possibility to compare the existing command with commands I have to use on the new switch. The documentation on the switch is not very helpful for doing this task. If someone could help it would be fine.
This is the current QoS configration used on the C3750 series switches, which I wanted to transform to the C4900M syntax - without success:
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...