04-03-2007 10:27 PM - edited 03-05-2019 03:17 PM
I have cisco 2600 router which already has 512 MB leased line connectivity. I would like to add an additional adsl line. can any one suggest me the possibility?
Thanks
04-03-2007 10:29 PM
Anup,
You can use ADSL's WIC on the 2600 router. You have to check the WIC slot avaialbility on your router.
WIC-1ADSL-I-DG 1-Port ADSLoISDN WAN Interface Card
WIC-1ADSL 1-port ADSL WAN Interface Card
WIC-1SHDSL 1-Port G.SHDSL WIC
WIC-1SHDSL-V2 1-Port two or four wire G.SHDSL WIC
WIC-1ADSL-DG 1-Port ADSL WAN Interface Card with Dying gasp
Please see the link below for WIC info
http://www.cisco.com/en/US/products/hw/routers/ps259/products_relevant_interfaces_and_modules.html
-amit singh
04-03-2007 11:29 PM
Dear Amit
ADSL WIC required IOS higher than v 12. which i cannot upgrade since my router does not have enough memory /flash.
now i am planning to install NM-1E - 1 port ethernet network module and connect ADSL line into it.
Can you tell me whether this card support 2600 router and how adsl can be configured.
Thanks, Anup
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: