ADSL using ZTE modem and Cisco 1760 with Ethernet WIC
I have a ZTE modem from my ISP and a cisco 1760. The ISP uses PPPOE authentication. The ZTE 831 modem/router allows me to disable the routing functions by creating a "bridge". How can I configure my cisco router to use pppoe authentication on the WIC card so I have my public IP on the cisco instead of having it on the modem?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...