Advertise Routing protocol from GLBP virtual address
I have a setup with 2 routers at each site on individual T1 links that I am running an IGP (eigrp) across and then using GLBP on the inside interfaces for load-balancing / fail over. When I am advertising the dynamic routing protocol into the core-switch at each location, the switches are peering with the physical address of the inside interface, and not the GLBP virtual address. I need to force this, or I guess I could just have the core switch default-route to the GLBP address.
One site is eigrp into the core, the other site I am redistributing eigrip into rip (hp switch as the core).
Re: Advertise Routing protocol from GLBP virtual address
GLBP/HSRP etc. are primarily used for end hosts to have redundant gateways and not by routing protocols which will always peer on the physical addresses, at least the IGP's anyway.
If you want load-balancing/failover then you don't need GLBP. The core switch should see 2 equal cost paths to both routers for all destinations on the WAN side assuming the core switch has a link to each router ?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...