I need advice on a new configuration I am trying to implement.
PC -- IP Phone -- Switches (2 3550 and 1 2950)
____ Router 1 ---- T1
|____ Router 2 ---- T1 (Routers will be
connected to the
Router 1 and 2 will be running GLBP for redundancy purposes. I was thinking about stacking the two 3550 and create a trunk with the 2950.
I have three departments, which I will separate with VLANs and also I will create a Server as well as a Voice VLAN.
Question, the 3550 have the SMI image: are they going to be able to route between VLANs even though it is not using its L3 capabilities? I am trying to keep the routers away from any internal routing. QoS will also be implemented.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...