Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Advice on RPS2300

Hi All,

I need to be able to provide redundant power to 2 x 2821 routers and 2 x 2960 switches.

I have a choice between using 2 x RPS2300, each with 2 of the 750 watt PSU's or simply using a static transfer switch (from APC or some other).

The RPS2300 solution will cost me about €4,000, but the static transfer switch will cost me about €600. Quite a difference!

I know the the RPS will protect from an internal PSU failure, but how likely is this?

I'm thinking of just getting a static switch, unless there are some (very!) compelling reasons to go with the RPS.

Your thoughts/comments/suggestions?

Thanks in advance

Kevin

124
Views
0
Helpful
0
Replies
CreatePlease to create content