i have a router that is working as Bras , and there are 3000 user as vi access ,
now i want to set policy to a subnet of user ,
the problem is when i perform the policy on a router interface , the router cpu is increased and reach 95 % and this cause the routet to hang ,
============>i have s samll vlan and want to control the traffic on it , which described in topology below
=========================================================
my question is ,
how to use policy map to check only a specific vlan , not to check all the 3000 users which as a result willl cause the cpu to he hanged ???
==============
hint ,
i want only to apply the policy to vlan 20 which has only 60 users , whereas the vlan 10 has a 3000 user ,
here is my topology
vlan 20
|
|
|
|
vlan 10--------------sw----------------router--------------------->internet
plz help me , where to put the policy and the best way to apply it ,
with my best regards
