Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Aironet 1130ag Multiple SSID & VLAN Tagging help

Hi,

On my computer I cannot ping the wlan router nor can I authenticate with the secure SSID.

I can connect to the unsecure SSID and reach the internet.

The switchport the router is connected to has trunking enabled for that port.The deafult vlan on the switch port is 1 though this shouldnt make a difference as all the traffic on the wlan router should be tagged

Router config attached.

Thanks in advance..

Ryan

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Aironet 1130ag Multiple SSID & VLAN Tagging help

I see that your router is configured with a native VLAN of 2 on the interface connecting to the switch. Can you make sure that the native vlan on the switch side is also 2? (command is "switchport trunk native vlan 2"). It could be that the router is sending vlan 2 traffic untagged and switch is expecting it to be tagged. Hope this helps.

Regards,

NT

3 REPLIES
Cisco Employee

Re: Aironet 1130ag Multiple SSID & VLAN Tagging help

I see that your router is configured with a native VLAN of 2 on the interface connecting to the switch. Can you make sure that the native vlan on the switch side is also 2? (command is "switchport trunk native vlan 2"). It could be that the router is sending vlan 2 traffic untagged and switch is expecting it to be tagged. Hope this helps.

Regards,

NT

New Member

Re: Aironet 1130ag Multiple SSID & VLAN Tagging help

No the default switch side is VLAN 1.

I'll try tweaking it

New Member

Re: Aironet 1130ag Multiple SSID & VLAN Tagging help

That was it..

I feel so stupid I missed that, I had noticed "other" traffic on vlan 1 when I was looking at it but it never clicked..

Thanks a bunch

1147
Views
0
Helpful
3
Replies