Well I am back, I was able to flash the IOS and I am able to access configuration. Now the issue is that I am trying to access the GUI, so I can configure the settings. The IP address the IPSU (thank you cisco) gives me the ip address of my access point, but when I do try to access it from the Internet (using firefox), I get a timeout error.
So anyone have any thoughts on my new and so unloved issue?
Yes, I did that and is the Http:// service working? I am truly not sure. I had to configure the FA0 to a 192.168.1.1/255.255.255.0 . My thinking was it would allow me to at least upload it... Apparently not, so Is there some SOP for the basic HTTP service? A simple yet effective way for me to add in some numbers so I can just get it to upload?
No, I can not ping the unit. Now, I dont have the config guild. My company bought out a smaller one, and I so happen to get this unit. So my bright self said lets put it to use, but its becoming more of a hassle then I think its worth(since I have no guide). I think I will just buy a new one.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...