I am getting Align-err on a port. Both sides are set to 100/full so I don't think there is a duplex problem. Also there is no HUB in the mix, it is connected directly to the switch. I am going to check the cabling. What else is anything could I check to resolve these errors. Also should I try and set the speed and duplex on both sides to Auto to see if there is a change? The errors are not rapidly going up just a handfull per hour, but I don't want to just let them go if I can correct them.
It could also be because of bad cabling, a bad port, or a bad NIC. So lets us try making both sides as auto auto first and if that does not resolve the best way to check is connect the same machine to different port and see if the errors follows is yes then check the cable and if cabling if fine it could be bad nic.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...