Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Align-Err & Runts from Cisco 6509

What are the Align-Err and Runts meaning when I got the error counts by show port command. And if I got these error counts, how can I solve the problem. Many thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Align-Err & Runts from Cisco 6509

Align-err and Runts are generally caused by duplex issues on the ports. Please make sure that both the sides are either hardcoded or set to auto to eliminate any such issues. You can try hardcoding the speed/duplex on switchports if it is set to auto.

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00800a7af0.shtml

HTH,Please rate if it does.

-amit singh

1 REPLY
Cisco Employee

Re: Align-Err & Runts from Cisco 6509

Align-err and Runts are generally caused by duplex issues on the ports. Please make sure that both the sides are either hardcoded or set to auto to eliminate any such issues. You can try hardcoding the speed/duplex on switchports if it is set to auto.

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00800a7af0.shtml

HTH,Please rate if it does.

-amit singh

1604
Views
0
Helpful
1
Replies