Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

All power supplies does not appear in "show inventory" in Cisco 3750X

Hi,

I have a stack of 2 x C3750X. I noticed that when from the output of "show inventory" command, all power supplies does not appear? Only three of them can be seen instead of four. When I checked on the switches physically, all power supplies are up and running. But when I do a "show env all" all four power supplies can be seen. Is it really like that in "show inventory"?

7 REPLIES
Cisco Employee

All power supplies does not appear in "show inventory" in Cisco

This is is known cosmetic bug. 12.2(58)SE have permanent fix. Upgrade to the fixed version you wont see the issue again.

Thanks,

Richard.

*Rate if its useful

New Member

Hi RichardI have WS-C3560E

Hi Richard

I have WS-C3560E-12SD-E series switches with IOS (3560e-universalk9-mz.12.2.53.SE1) having two supplies (C3K-PWR-300WAC) installed. I noticed

that only one power supply is showing in 'show env'. But i can see both the suplies in 'show inventory'. I checked the power supplies LED and all LEDs showing Green.


While i can see both power supplies in 'show env' & 'show inventory' on the same model (WS-C3560E-12SD-E) of switches running IOS 12.2.52.SE & 12.2.50.SE2

New Member

Hello Richard,Looks like I've

Hello Richard,

Looks like I've encountered this. What's the bug ID please?

Thanks

New Member

Hi AllanCSCtf76684 (Only one

Hi Allan

CSCtf76684 (Only one power supply displayed in "show env all")

New Member

Thanks Farooq :-)

Thanks Farooq :-)

New Member

Dear AllanPlease rate if

Dear Allan

Please rate if useful.

I'm running 12.2(58)SE2 on

I'm running 12.2(58)SE2 on some 3750X switches and I'm seeing the opposite cosmetic bug.
 

"show inventory" only has one power supply listed for each of two stack members.
"show env power all" shows me both power supplies in the two stack members.

1019
Views
10
Helpful
7
Replies
CreatePlease login to create content