Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

All systems can see each other except PIX can't see one server

I have a PIX (to the internet) and 2 servers connected to a router.

From the router, I can ping both servers and the PIX without a problem.

From each server, I can ping the other, the router, and the PIX.

From the PIX, I can ping the router but ONLY ONE of the servers.

Here is a 'show route' from the PIX:

outside 0.0.0.0 0.0.0.0 <ISP_ROUTER> 1 OTHER static

inside 192.168.0.0 255.255.0.0 <OUR_ROUTER> 1 OTHER static

inside <PUBLIC_IP1> 255.255.255.255 192.168.77.77 1 OTHER static

inside <PUBLIC_IP2> 255.255.255.255 192.168.77.77 1 OTHER static

The servers are 192.168.77.77 & 192.168.77.88. I can get to ...77 but not ...88. However, lines 3 & 4 above have to do with public access to Server1, nothing to do with getting from the PIX command line to ...77 so I don't see the problem here.

Any ideas?

2 REPLIES

Re: All systems can see each other except PIX can't see one serv

What's the IP address/subnet mask of the PIX inside interface and the router interface that connects to the PIX?

New Member

Re: All systems can see each other except PIX can't see one serv

PIX:

ip address inside 192.168.66.2 255.255.255.0

ROUTER:

interface GigabitEthernet1/0/1

description INTERNET FIREWALL

no switchport

ip address 192.168.66.1 255.255.255.0

no mdix auto

!

97
Views
0
Helpful
2
Replies