05-15-2007 02:10 PM - edited 03-05-2019 04:05 PM
I have just receive a brand new catalyst Express 500 Series, to replace a catalyst 3500 XL, that was borrough, and I am amazed that I don't hav access to a command line to configure the switch. I would like to copy the existing config of my Catalyst 3500 Swicth, into the catalyst Express 500.
How can I do that ???
Solved! Go to Solution.
05-15-2007 07:14 PM
05-15-2007 03:53 PM
If it doesn't have command line you can't you will have to figure out the equivalent commands in the new switch via the gui interface .
05-15-2007 07:14 PM
Hope this link helps..
http://www.cisco.com/en/US/products/ps6545/products_configuration_example09186a00806da6c9.shtml
regds
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide