Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Amazing......

I have just receive a brand new catalyst Express 500 Series, to replace a catalyst 3500 XL, that was borrough, and I am amazed that I don't hav access to a command line to configure the switch. I would like to copy the existing config of my Catalyst 3500 Swicth, into the catalyst Express 500.

How can I do that ???

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Amazing......

2 REPLIES
Purple

Re: Amazing......

If it doesn't have command line you can't you will have to figure out the equivalent commands in the new switch via the gui interface .

Re: Amazing......

175
Views
0
Helpful
2
Replies