Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Anyway to stop an interface from SENDing the bpdu?

The interface is configured as a trunk:

int g1/0/1

switchport trunk encapsulation dot1q

switchport mode trunk

The spanning-tree protocal is MST. Is there anyway to stop this interface from sending out BPDUs? Portfast will only work on Access port...

Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: Anyway to stop an interface from SENDing the bpdu?

2 REPLIES
Hall of Fame Super Bronze

Re: Anyway to stop an interface from SENDing the bpdu?

New Member

Re: Anyway to stop an interface from SENDing the bpdu?

Depending on your platform/IOS to enable Port Fast on trunk ports, you must use the

-if #spanning-tree portfast trunk

interface configuration command.

If you have redundant trunks, you may want to look into uplinkfast.

http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a0080094641.shtml

353
Views
0
Helpful
2
Replies
CreatePlease to create content