01-28-2009 01:23 PM - edited 03-06-2019 03:43 AM
The interface is configured as a trunk:
int g1/0/1
switchport trunk encapsulation dot1q
switchport mode trunk
The spanning-tree protocal is MST. Is there anyway to stop this interface from sending out BPDUs? Portfast will only work on Access port...
Thanks!
Solved! Go to Solution.
01-28-2009 03:06 PM
01-28-2009 03:06 PM
01-29-2009 12:54 PM
Depending on your platform/IOS to enable Port Fast on trunk ports, you must use the
-if #spanning-tree portfast trunk
interface configuration command.
If you have redundant trunks, you may want to look into uplinkfast.
http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a0080094641.shtml
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide