I have installed AP1242 access point in rather harsh environment indoors. The AP is in 3 meters below the ceiling of the warehouse, however, the ceiling is not completely sealed. I've installed the AP on the vertical surface, so the upper side of 1242 is in 3 meters from the ceiling. 1242 has a hole on its upper side (with lock pictogram near it). I'm afraid that some amount of water can hit the upper side of 1242 and get to that hole.
Kindly advise if it is safe to use 1242 in such conditions.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...