cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
366
Views
0
Helpful
4
Replies

AP801 looses the configuration after power outage.

achyut.chalise
Level 1
Level 1

I have Cisco881W router, I configured router and AP801 but some reason AP looses the configuration after power outage. Config-reg setup to 0xf to AP 801 ?

How do I change the Config-register on AP801 ?

Thank you,

Achyut

4 Replies 4

Hi 

Share me show version of your AP801

 

HTH

Sandy

Thank you for promp reply, here is brief of the show version

ap801>show version

Cisco IOS Software, AP801 Software (AP801-K9W7-M), Version 15.2.4-JA1, RELEASE SOFTWARE
(fc2)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2009 by Cisco Systems, Inc.

config-register 0xF

Cisco IOS Software, AP801 Software (AP801-K9W7-M), Version 15.2(4)JA1, RELEASE S                                                                             OFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2013 by Cisco Systems, Inc.
Compiled Tue 30-Jul-13 23:57 by prod_rel_team

ROM: Bootstrap program is AP801 boot loader
BOOTLDR: AP801 Boot Loader (AP801-BOOT-M) Version 12.4(10b)JDA3, RELEASE SOFTWAR                                                                             E (fc1)

ap uptime is 19 hours, 13 minutes
System returned to ROM by power-on
System image file is "flash:/ap801-k9w7-mx.152-4.JA1/ap801-k9w7-mx.152-4.JA1"
Last reload reason:

 

This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html

If you require further assistance please contact us by sending email to
export@cisco.com.

cisco AP801GN-A-K9 (PowerPC 8343) processor (revision C0) with 49142K/16384K bytes of memory.
Processor board ID FTX1433822Q
PowerPC 8343 CPU at 400Mhz, revision number 0x0031
Last reset from power-on
1 Gigabit Ethernet interface
1 802.11 Radio

32K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address: F8:66:F2:AB:45:94
Part Number                          : 73-11027-07
PCA Assembly Number                  : 800-28807-07
PCA Revision Number                  : B0
PCB Serial Number                    : FOC142949ET
Top Assembly Part Number             : 800-29556-04
Top Assembly Serial Number           : FTX1453822Q
Top Revision Number                  : B0
Product/Model Number                 : AP801GN-A-K9

 

Configuration register is 0xF

Thanks I figured it out..

AP was in unified boot image. I Cahnge to autonomous mode.

 

 

Review Cisco Networking products for a $25 gift card