Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

apply ACL on vlan

       Amended the post     

Hello

can someone guide how to  apply access-list to a vlan

office_A connect to Office_B on different floors on vlan 10

need to allow inbond and outbond traffic

Config of Office_A and host

VLAN

int vlan 10

ip address 192.168.177.254 255.255.255.252

Allow the following host to communicate with host of Office_B

host 192.168.110 port 443

host 192.168.1.16

network 192.168.25.0/24

Network of Office_B

allow following host to communicate with hos of Office_A

192.168.100.10  port 443

1192.168.100.17

192.168.27.0/24

plz guide with right inbond / outbond acl to apply on SVI

thanks

Vishal

1 REPLY
New Member

apply ACL on vlan

Just to be on the same side, you want hosts 192.168.1.10:443 & 192.168.1.16 to connect to 192.168.100.10:443 and hosts 192.168.100.10:443 & 192.168.100.17 to connect to 192.168.110:443?

I'm asking because I got confused from your question. If you have a topology for your network, it would be of great asset.

Best Regards,

Islam M. Nadim

136
Views
0
Helpful
1
Replies
CreatePlease to create content