I understand that the CISCO's recommendation for ARP timeout value is to bring it down to the default CAM timeout of 300 seconds. This is done on the router module under each VLAN interface. However, on the 6513 switch side there is a global default setting of 1200 seconds for ARP Agetime. My question is, should this value also be set to 300 seconds? by issuing the SET ARP Agetime 300 command.
I believe whatever you set on the interface will override the global setting which is used if no other arp timer is set on the interfaces. If you want all your interfaces to change just readjust the global timer .
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...