Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ARP cache on Router not correct

Hi,

Router A has a LAN interface with 2 physical ip address(pri + secondary IP). The primary inf is connected to the same firewall segment. The secondary inf is connected to the switch management IP.

After various ping to the secondary IP(192.1.1.10) from the switch, which failed, i did a 'show arp' on the router and realised that the switch ip is binded dynamically to the firewall MAC instead of the switch(3com) MAC.

interface Ethernet0/0

ip address 192.1.1.10 255.255.255.0 secondary

ip address 10.226.16.1 255.255.248.0

ipx network 1

!

Can anyone explain this? Is it a bug?

  • LAN Switching and Routing
3 REPLIES
New Member

Re: ARP cache on Router not correct

RouterA#show arp | in a373

Protocol Address Age (min) Hardware Addr

Internet 192.1.1.101 120 0000.a710.a373

Internet 192.1.1.102 120 0000.a710.a373

Internet 192.1.1.103 120 0000.a710.a373

Internet 192.1.1.99 120 0000.a710.a373

0000.a710.a373 is the MAC of the checkpoint Inf.

IPs are the switch mngt IP.

New Member

Re: ARP cache on Router not correct

Is there any possibility of duplicate addresses.Please check the logs with "show logging" and look for any messgages.

Silver

Re: ARP cache on Router not correct

try to eliminate the firewall and then ping the router, may be the firewall configuration is the cause

193
Views
0
Helpful
3
Replies
This widget could not be displayed.