I'm facing issue here, as often ARP age-out in the time interval of 50 sec on particular vlan. Due to which that respective vlan servers are hitting with a impact.
Here the ARP age-out is configured default as per the NX-OS its 1500-sec (25-min). On contrary other vlans are doing good with their default age-out timer, as they have the flushing on XX mins. Only this vlan is going weird with flush time of 50 sec even though its 1500 as default.
Seeking on your suggestions.
N7K-switch# sh ip arp vlan 2
Flags: * - Adjacencies learnt on non-active FHRP router + - Adjacencies synced via CFSoE # - Adjacencies Throttled for Glean D - Static Adjacencies attached to down interface
IP ARP Table Total number of entries: 6 Address Age MAC Address Interface 10.0.0.1 00:00:15 0036.bxx4.xxx8 Vlan2 10.0.0.2 00:00:42 0036.b96a.45e5 Vlan2 10.0.0.3 00:00:19 0036.bxxb.b26f Vlan2 10.0.0.4 00:00:11 bxx0.5bd0.7752 Vlan2
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...