Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AS-5350 FAIL

hi a has a AS-5350 installed this weekend for something that i dont know fails. i Get the looger atach before reboot.

The problem was that de E1 Controller were out do not respond, even i could not make it telnet only ping. i get connected him by console port i make a write men, save the logg.

After this the in g0/0 does not have an ip address. can someone help me.

2 REPLIES
Bronze

Re: AS-5350 FAIL

The only workaround at this point is to reload the box. You can monitor this with the show chunk output and look at the elements in use for the VTSP event pool. This number will probably keep incrementing all the time till you run out of memory.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_release_note09186a008015a80e.html#wp312827

The following document explains the symptoms and possible causes of memory allocation failure (MALLOCFAIL), and offers guidelines for troubleshooting memory problems.

http://www.cisco.com/warp/public/63/mallocfail.shtml

Silver

Re: AS-5350 FAIL

Hi ,

which IOS you are running in as-5350.

Thanks,

satish

118
Views
0
Helpful
2
Replies