Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

AS5350 r2

Good afternoon. There is a scheme: Cisco AS5350 it is connected on R2 to automatic telephone exchange Alcatel s12. Prompt, why if Cisco AS5350 it is connected on R2 gives only 4 figures calling. (with ISDN Cisco AS5350 gives number calling)

It is adjusted(is set up) so:

controller E1 1/1

framing NO-CRC4

ds0-group 0 timeslots 1-15,17-31 type r2-digital r2-compelled ani

cas-custom 0

country easteurope

seizure-ack-time 50

dnis-complete

timer interdigit incoming 3000

1 REPLY
Anonymous
N/A

Re: AS5350 r2

R2 signaling is a channel associated signaling (CAS) system developed in the 1960s that is still in use today in Europe, Latin America, Australia, and Asia. R2 signaling exists in several country versions or variants, in an international version called Consultative Committee for International Telegraph and Telephone (CCITT-R2). The R2 signaling specifications are contained in ITU-T Recommendations Q.400 through Q.490. E1 R2 signaling is an international signaling standard that is common to channelized E1 networks. E1 R2 signaling has been supported on the Cisco AS5200, 5300, and 5800 series access routers. E1 R2 signaling was introduced to the Cisco 2600/3600 series routers in Cisco IOS? Software Release 12.1.2XH and 12.1(3)T. E1 R2 is also supported on the E1 voice WAN interface cards (VWICs), which can be inserted into the WIC slot on the IAD2430s. Furthermore, Cisco AS5350, 5400, and 5850 also support this application.

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a008024903b.shtml

176
Views
0
Helpful
1
Replies
CreatePlease to create content