Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

ASA 5505 POE

I have an ASA 5505, I enable ports 6 and 7. Configured auto for speed and duplex. I cannot get the ports on.

The device is AXIS T8129 PoE extender and the compliant standards are the following:

IEEE 802.3af, IEEE 802.3at

The extebder should be compliant with the ASA.

#sh power inline

Interface   Power   Device

---------   -----   ------

Et0/0        n/a    n/a

Et0/1        n/a    n/a

Et0/2        n/a    n/a

Et0/3        n/a    n/a

Et0/4        n/a    n/a

Et0/5        n/a    n/a

Et0/6        Off    n/a

Et0/7        Off    n/a

Thanks in advance,

Bobby

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

ASA 5505 POE

Hi,

Et0/6        Off    n/a

Et0/7        Off    n/a

Did you no shut these 2 ports which are the only ones supporting PoE  ?

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
3 REPLIES
Purple

ASA 5505 POE

Hi,

Et0/6        Off    n/a

Et0/7        Off    n/a

Did you no shut these 2 ports which are the only ones supporting PoE  ?

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
New Member

ASA 5505 POE

I did do the no shut command.

I think it is the devices themselves because I grabbed an IP phone and instantly the port supplied PoE.

Thanks,

I probably need to close this post

New Member

ASA 5505 POE

Actually I found out you have to run LLDP on a switch since it is a non-cisco device. Can you run LLDP on a ASA 5505?

276
Views
0
Helpful
3
Replies
CreatePlease to create content