ASA 8.2 - Static NAT and Dynamic NAT Policy together
I have the following problem using a ASA with version 8.2.
1) I have this segment on interface Ethernet 0/0: 192.168.1.0/24
2) Through interface Ethernet 0/1 I will reach several servers using the same source IP, but other servers must be reached using only one IP, for example 192.168.1.70
so, I have configured a Static NAT Rule from interface Ethernet0/0 to interface Ethernet 0/1 which NAT the source IPs to the same IPs: 192.168.1.0/24->192.168.1.0/24. Also I have configured a Dynamic NAT Policy that states when destination IP is "server list" then all the source IPs must be translated to 192.168.1.70.
PROBLEM: when testing it...always the static wins....and Dynamic is never analyzed...Also, no priority for the NAT policy and NAT rules can be done on ASDM...what can I do? is there a way to do this on ASDM or CLI? (preferrely at ASDM)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...