Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
Gold

ASA NAT and XBOX360

I wounder if anyone have a good solution to which ports to do a static on to open a XBOX360.

I have opened and made statics the 5 that microsoft says to open but still i get Moderate when i use the XBOX.

The ports i have made statics on are:

UDP 53

UDP 88

UDP 3074

TCP 3074

UDP 3330 (I think it was this one but I need to check when i get to the machine.)

No I do not want to use up a whole ip address and do a static on that.

Thanx for any help

Regards

Torbjorn

1 ACCEPTED SOLUTION

Accepted Solutions

Re: ASA NAT and XBOX360

What do your statics look like? And the ACL?

Should be something like-

static (inside,outside) udp interface 88 [inside IP] 88 netmask 255.255.255.255

Then you need to allow the port in your ACL-

access-list outside_access extended permit udp any interface eq 88

I don't think you need UDP 53, that's DNS lookup. This is only needed id your host DNS.

HTH and please rate.

2 REPLIES

Re: ASA NAT and XBOX360

What do your statics look like? And the ACL?

Should be something like-

static (inside,outside) udp interface 88 [inside IP] 88 netmask 255.255.255.255

Then you need to allow the port in your ACL-

access-list outside_access extended permit udp any interface eq 88

I don't think you need UDP 53, that's DNS lookup. This is only needed id your host DNS.

HTH and please rate.

Gold

Re: ASA NAT and XBOX360

I feel so stupid.

I had totally forgotten to use interface instead of the ip adress

Thanx for reminding me.

Works like a charm.

229
Views
0
Helpful
2
Replies
CreatePlease to create content