On the FWSM there is an onboard console port, on the ASASM were is it located.
After upgrading the ASASM from 8.5 to 9.0 the ASA-SM is not responding at all and shown as unknown in the show module command. the status led on the module is RED. tried the boot cf:1 cf:4 commands but nothing. these commands are for the FWSM THOUGH. found no documentation for ASASM at all for troubleshooting or if these cf: commands are the same.
You should be able to use the service-module session command (link) to access the virtual console. You can observe the boot process after a module reset and see if rommon is perhaps not fining a valid image.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.