currently physical interfaces 0/0 and 0/1 are in use
I have now enabled 0/2 interface and I am trying to test creation and use of VLANs on that interface. hence i created a subinterface 0/2.7 which i called testvlan
what I would like to do is enable traffic between 0/1 and 0/2.7
I would also like 0/2.7 to be able to access the internet through the 0/0 (outside) interface
i have tried various things and I can only get one of those two things to work. I can either talk between 0/1 and 0/2.7 and can't access the internet from 0/2.7 (it appears because there is no NAT for testvlan and outside)
I can access the internet from 0/2.7 but only by IP (DNS resolution fails because the DNS server is on 0/1 network) and i cannot talk between 0/1 and 0/2.7
any help as far as the proper configuration is concerned would be very appreciated.
this let's me talk between 0/1 and 0/2.7 but with this i cannot get to the internet. If I do a packet trace, there is no rule that blocks the traffic (according to the ASDM), but there is also no NAT rule that is used in the trace
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.