11-06-2008 04:49 AM - edited 03-06-2019 02:20 AM
Hi,
I'm configuring an ASA5520.
Is it possible to give the ASA a router id manually? If yes, whats the command for?
It should not use the highest ip address.
thanks and greetings lydia
Solved! Go to Solution.
11-06-2008 05:02 AM
Lydia
Yes it is possible, see attached link -
http://www.cisco.com/en/US/docs/security/asa/asa72/command/reference/qr_72.html#wp1655194
Jon
11-06-2008 05:03 AM
Hi,
"router-id 1.1.1.1".
router ospf 100
router-id 1.1.1.1
http://www.cisco.com/en/US/docs/security/asa/asa72/command/reference/qr_72.html#wp1655194
Regards,
Arul
*Pls rate if it helps*
11-06-2008 05:02 AM
Lydia
Yes it is possible, see attached link -
http://www.cisco.com/en/US/docs/security/asa/asa72/command/reference/qr_72.html#wp1655194
Jon
11-07-2008 04:56 AM
thank you very much
11-06-2008 05:03 AM
Hi,
"router-id 1.1.1.1".
router ospf 100
router-id 1.1.1.1
http://www.cisco.com/en/US/docs/security/asa/asa72/command/reference/qr_72.html#wp1655194
Regards,
Arul
*Pls rate if it helps*
11-07-2008 04:56 AM
thanks a lot!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide