Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ASR 1001 Arp table

I have an ASR that is connected to a switch.  Even though there are no devices plugged into the switch, the asr's arp table shows there are.  The arp entries are of devices there have been removed from the switch.  I cannot get rid of these arp entries on the asr.  Am i missing something?

3 REPLIES
Community Member

Re: ASR 1001 Arp table

Did you run the following command:

"clear arp-cache interface" (followed by the interface number)

or

"clear arp-cache" ( followed by the IP Address)

Community Member

Re: ASR 1001 Arp table

Hello Jignesh,

Please, share the following outputs from the box in order to get a view of the stale entires.

# show ip arp

or

# show ip arp vrf

Thank you

-- 
Best regards,
Dmitry Skotnikov

-- Best regards, Dmitry Skotnikov
Community Member

Re: ASR 1001 Arp table

Thanks for the response.  I ended up rebooting the router.  That cleared the arp table.  I did issue the commands in this post, but did not remove the entries.  Will see what happens again.

682
Views
0
Helpful
3
Replies
CreatePlease to create content